During a walk with the dog I discovered at the
station in Hennen special aparatuses. What did they do? Look
here !
May 13
A new car went into service
This CMX Cleaning car started as brass model.
At first it got a primer and some time in the oven. Then came
glossy black with the airbrush. Next step after drying time, decals.
To seal the decals I airbrushed with Dullcote. Next day I started
some light weathering. Trucks and wheels got a rusty look. And
the body got a light white overspray, one drop white with much
thinner. Then I used the felt
tip pen procedure I've learned from Peter.
May 5
Today I've finished my work with my Alco RSD-5. Now this engine
has a working beacon light and sound:
May 2
I wanted to run a few trains. At first I switched a little bit.
Then came the grain unit. I throw all turnouts at staging yard,
starting point, International Falls. And all turnouts at the end,
at South Jct. And slowly I run the train. Suddenly it stopped.
And I recognized my big mistake:
The first engine has lost contact - and the train
stopped. Perhaps it blocked someway. I was lucky, the train did
not fall on the floor, 50'' deeper!
Diese Seite wurde zusammengestellt von / This
page was created by Wolfgang Dudler.
Eine Verantwortung für Fehler und Unterlassungen wird ausdrücklich
abgelehnt.
Responsibility for errors and ommissions is expressively rejected.