|
||
At first I wanted the segments like my other curved modules, 22,5°, 2m radius. This are 785mm long trapezoidal segments. But this was too small. I “couldn’t get the curve.” The radius would be too small. So I’ve made a test track. I made the
drawing with different radii and glued to my templates the ties. Track
is soldered according to the centerline. I’ve tested
with my friend Friedhelm different H0n3 engines. They will run down
to 400 mm radius, and the Blackstone K27 should make 18’’,
but rumor says it will make 17’’ too.
|
||
|
|
|||
|
|||
|